Input |
Input Coupling |
AC, DC, GND |
Input Impedance |
DC: 1MΩ ± 2% || 17pF ± 3pF AC: 1.2 MΩ ± 2% || 17pF ± 3pF, < =100mV/div 1.0 MΩ ± 2% || 17pF ± 3pF, >100mV/div |
Maximum Input Voltage |
± 400V PK-PK CATI |
Ch to Ch Isolation (Both channels in same V/div setting) |
>100:1 at 20 MHz |
Probe attenuator |
1X, 10X |
Probe attenuator |
1X, 10X, 100X, 1000X |
Horizontal System |
Real Time Sampling Rate |
Single Channel 500 MSa/S; Double Channels 250 MSa/s |
Equivalent Sampling Rate |
50GSa/s |
Measure Display Modes |
main, window, window zoom, scan, x-y |
Timebase Accuracy |
±100ppm measured over 10 ms interval |
Time Window |
12 Divisions |
Vertical System |
Vertical Sensitivity |
2mV-10V/div at input BNC (1-2-5 order) |
Channel voltage offset range |
2 mV-200mV: ±1.6V 206mV-10V: ± 40V in Fixed Gain Ranges & Variable Gain Ranges |
Vertical Resolution |
8 bit |
Channels |
2 |
Analog Bandwidth (at input BNC) |
40 MHz |
BW Flatness |
DC-10% of rated BW: ± 1dB 10%-50% of rated BW: ± 2dB 50%-100% of rated BW: ± 3dB |
Lower frequency limit (AC -3dB) |
≤10 Hz (at input BNC) |
Noise: Pk-Pk for 3K record |
≤ 0.6 Div for average of 10Pk-Pk readings in fixed gain settings. < = 0.7 Div for average of 10 Pk-Pk readings, Variable gain settings |
SFDR including harmonics |
≥ 40dB |
DC Gain Accuracy |
< ± 3.0%: 5mV/div to 5V/div in Fixed Gain Ranges < ± 4.0%:typical for 2mV/div and Variable Gain Ranges |
DC Measurement Accuracy: All Gain settings ≤100mV/div |
± [3%X (|reading|+|offset|) +1% of |offset| +0.2div+2mV] +0.2div+2mV] |
DC Measurement Accuracy: All Gain settings>100mV/div |
± [3%X (|reading|+|offset|) +1% of |offset| +0.2div+100mV] |
Math operation |
+,-, *,FFT |
FFT |
Window mode: Hanning, Hamming, Blackman, Rectangular |
Bandwidth limiter |
20MHz ± 40% Typical (Note: BW limited below 20MHz ± 40% when using probe X1) |
Trigger System |
Trigger Types |
Edge, Pulse Width, Video, Slope, Alternative |
Trigger Modes |
Auto, Normal, Single |
Trigger Sources |
Ch1-2, EXT, EXT/5, AC Line |
Trigger Coupling |
AC, DC, LF rej, HF rej |
Trigger Level Range |
CH1, CH2: ±6divisions from center of screen EXT: ±1.2V EXT/5: ± 6V |
Trigger Level Accuracy (typical) applicable for the signal of rising and falling time ≥ 20ns |
Internal: ±(0.2 div×V/div)( within ± 4 divisions from center of screen) EXT: ±(6% of setting + 40 mV) EXT/5: ±(6% of setting + 200 mV) |
Edge Trigger |
Edge type: Rising, Falling, Rising and Falling |
Pulse Width Trigger |
Trigger Modes: (>,<,=) Positive Pulse Width, (>,<,=)Negative Pulse Width Pulse Width Range: 20ns-10s |
Video Trigger |
Support signal Formats: PAL/SECAM, NTSC Trigger condition: odd field, even field, all lines, line Num |
Slope Trigger |
(>,<,=) Positive slope, (>,<,=)Negative Slope Time: 20ns-10s |
Alternative Trigger |
CH1 trigger type: Edge, Pulse, Video, Slope CH2 trigger type: Edge, Pulse, Video, Slope |
Control Panel Function |
Auto Set |
Auto adjusting the Vertical, Horizontal system and Trigger Position |
Save/Recall |
Support 2 Group referenced Waveforms, 20 Group setups, 20 Group captured Waveforms internal Storage/Recall function and USB flash driver storage function. |
Hard Ware Frequency Counter |
Reading resolution |
6 Bytes |
Accuracy |
± 0.01% |
Range |
DC Couple, 10Hz to MAX Bandwidth |
Signal Types |
Satisfying all Trigger signal (Except Pulse width trigger and Video Trigger) |
Acquisition System |
Sample Types |
Real time, Equivalent time |
Memory Depth |
Channel Mode |
Sampling Rate |
Short memory |
Long Memory |
Single Channel |
1GS/s |
40kpts |
No Support |
Single Channel |
500 MSa/s or lower 20kpts -500 MSa/s |
20 Kpts |
2 Mpts |
Double Channels |
500 MSa/s or lower 20kpts -500 MSa/s |
20 Kpts |
1 Mpts |
Sample Mode |
Sample, Peak Measure, Average |
Averages |
4,16,32,64,128,256 |
Measure System |
Auto Measure |
Vpp, Vmax, Vmin, Vamp, Vtop, Vbase, Vavg, Mean, Crms, Vrms, ROVShoot, FOVShoot, RPREShoot, FPREShoot, Rise time, Fall time, Freq, Period, +Wid, -Wid, +Dut, -Dut, Bwid, Phase, FRR, FRF, FFR, FFF,LRR,LRF, LFR, LFF |
Cursor Measure |
Manual mode, Track mode and Auto mode |
Display |
Display Mode |
Color TFT 5.7″ (145mm) diagonal Liquid Crystal Display |
Resolution |
320 horizontal by 234 vertical pixels |
Display Color |
64K color |
Display Contrast (Typical state) |
150:1 |
Backlight Intensity (Typical state) |
300 |
Wave display range |
8 x 12 div |
Wave Display Mode |
Point, Vector |
Point, Vector |
Off, 1 sec, 2 sec, 5 sec, Infinite |
Menu Display |
2 sec, 5 sec, 10 sec, 20 sec, Infinite |
Skin |
Succinct |
Screen saver |
1min, 2min, 5min, 10min,15min, 30min, 1hour, 2hour, 5hour, off |
Waveform Interpolation |
Sin(x)/x, Linear |
Color model |
Normal , Invert |
Language |
English, French, German, Russian, Spanish, Simplified Chinese, Traditional Chinese, Portuguese, Japanese, Korean, Italian, Arabic |
Interface |
USB Host, USB Device, RS232, Pass/Fail output |
Power Supply |
Input Voltage |
100-240 VAC, CAT II, Auto selection |
Frequency Scope |
45 Hz to 440 Hz |
Power |
50VA Max |
General Characteristics |
Dimension (L × W × H), mm |
305 × 133 × 154 |
Weight |
2.3 kg |
Reviews
There are no reviews yet.